This is a simple but useful post on removing nails from pallet boards. I used a small pallet and made it into my jig 
Next step is to place you board with the nails on the jig, nail side up. As you can see I have the nails in the middle of the jig.
Its handy to have a small sledge hammer to make the job easier. Just pound the nail back through the board.
From here its a simple matter of using your crow bar and pry out the nails, which should be an easy job.
And there you have is a pallet board ready for you next project.
And here is the start of my next project. A pallet trunk.
I’ll be posting my pallet trunk build
Leave a Reply